Maintenance & Troubleshooting

4.1 Regular Maintenance #

Keep your AquaSkim running efficiently with routine care:

Trash Basket Maintenance

• Press the lid release button to open the top compartment.
• Remove the trash basket and empty any collected debris.
• Rinse the basket with clean water and let it dry if needed.
• Reinsert the trash basket securely before use.

Solar Panel Cleaning

• Wipe down solar panels regularly to maintain charging efficiency.
• Remove dust, leaves, and debris using a damp cloth or gentle rinse.
• Dry panels with a soft, clean towel.

Ultrasonic Sensor Cleaning

• Inspect the sensors periodically for dust, water stains, or debris.
• Gently clean with a soft, dry towel to ensure accurate navigation.

4.2 Common Issues & Fixes #

Troubleshoot common AquaSkim problems with these quick solutions:

Device Will Not Start

• Ensure the power switch is turned on.
• Charge the unit using solar power or the Type-C adapter.
• Check for full trash basket and empty if needed.
• Verify no alarm or fault is active by checking the LED or app.
• Make sure the unit is not in manual-only mode — enable auto mode via app.

Unit Not Charging

• Confirm the power switch is in the “on” position.
• Make sure the Type-C charging cable is fully connected.
• If charging outdoors, ensure the unit is in direct sunlight.

Device Rotates in Place

• The ultrasonic sensor may be dirty or water-stained.
• Clean the sensor gently with a soft towel and restart the unit.

Low Battery Warning

• When the LED flashes red, the battery is below 20%.
• Place the AquaSkim in sunlight or charge with a Type-C adapter.
• Device resumes operation automatically at 30% battery.

Trash Basket Full Alert

• Red “breathing” light indicates a full basket.
• Empty the basket and restart the machine.

Steady Red Light

• A system fault has been detected.
• Check for obstructions, jammed parts, or full trash basket.

4.3 Resetting the AquaSkim #

If AquaSkim is unresponsive or acting abnormally:

• Turn off the power switch and wait 10 seconds.
• Turn the unit back on and observe the LED indicator.
• If problems persist, open the Illuminex App and tap “Factory Reset” under device settings.
• Follow in-app instructions to re-pair the device if necessary.
• After reset, ensure trash basket is empty and sensors are clean before restarting.