AquaChlor Salt Chlorine Generator

AquaChlor converts salt into chlorine automatically:

• Pool types: In-ground, vinyl, fiberglass, concrete

• Plumbing: 1.5" or 2"

• Salt level: 3,000–3,500 ppm (use pool-grade salt, 99% pure or higher)

• Built-in winter mode: 50% power for cold weather

• Warranty: 2 years

Not recommended for pools under 5,000 gallons.

1. Install the cell on the return line, after the heater

2. Mount the control box at eye level, sheltered from rain

3. Wire to a dedicated GFCI circuit

4. Add salt: aim for 3,000–3,500 ppm

5. Run the pump for 24 hours before turning on the chlorinator

6. Pair with Illuminex app

• Salt: 3,000–3,500 ppm

• Free chlorine: 1–3 ppm

• pH: 7.2–7.6

• Alkalinity: 80–120 ppm

• Calcium hardness: 200–400 ppm

• Cyanuric acid: 30–50 ppm

Test salt weekly and adjust as needed. See our salt level guide.

Clean the cell every 3–6 months (or when scaling appears):

1. Turn off the chlorinator and pump

2. Remove the cell from the plumbing

3. Mix muriatic acid and water (1:4 ratio) in a non-metallic container

4. Soak cell for 10–15 minutes

5. Rinse thoroughly with fresh water

6. Reinstall

The cell has self-cleaning auto-polarity, but manual cleaning is still recommended periodically.

No chlorine production: Check salt levels, clean the cell, ensure proper water flow.

Low salt warning: Add salt and allow 24 hours for full circulation.

Flow sensor error: Ensure pump is running and water flow is unobstructed.

Cold weather (below 60°F): Chlorine production reduces or stops. Use winter mode or shut off and store the unit.