AquaFall RGBW Acrylic Sheer Descent

AquaFall creates a clean sheet of moving water that adds motion, sound and nighttime illumination to modern pool environments.

Water appearance depends on correct flow, level installation, mounting height, plumbing design and environmental conditions. The water curtain may not remain perfectly uniform when flow is below the recommended level, plumbing is improperly balanced, the product is installed out of level, debris is present, wind conditions disrupt the water, or mounting height exceeds the approved limit.

Integrated RGBW lighting adds vivid colour, dedicated white illumination and supported dynamic lighting shows to the moving water.

A compatible Illuminex lighting controller is required for app-based control. Specific switching sequences and colour availability depend on the connected controller and approved documentation.

Correct water flow helps AquaFall produce a smooth, consistent water curtain across the full spillway width.

These values are calculated from the recommended 12 GPM per linear foot. Final pump and plumbing requirements depend on system head and installation conditions. The calculated GPM alone does not determine the correct pump selection.

AquaFall is designed for installations up to three feet above the pool waterline when installed and supplied according to the approved product requirements. The maximum height is not a recommendation for every installation — actual mounting height should follow the approved AquaFall installation instructions.

• Install AquaFall level across its complete width.
• Position the spillway according to the approved wall and coping design.
• Keep mounting height at or below three feet above the waterline.
• Connect the rear-mounted 1.5-inch slip inlet using approved pool plumbing.
• Design for approximately 12 GPM per linear foot.
• Account for system head when selecting the pump.
• Use valves or balancing equipment when required by the plumbing design.
• Provide access for future inspection and service.
• Protect the acrylic body during surrounding construction.
• Follow the approved AquaFall installation instructions.
• Follow applicable pool, plumbing, electrical and local requirements.

• Use a compatible pool-rated 12V AC transformer.
• Never connect AquaFall lighting directly to household line voltage.
• Disconnect power before installation or servicing.
• Use approved outdoor and pool-light electrical connections.
• Keep all electrical connections in approved protected locations.
• Follow the transformer and controller load requirements.
• Use a qualified pool or electrical professional.
• Follow applicable electrical and local-code requirements.

• AquaFall sheer-descent unit — Model-specific acrylic waterfall body
• Factory-installed RGBW lighting — Integrated into the water feature
• Factory lighting cord — 10 ft cord length
• Installation instructions — AquaFall installation guide

A compatible pool-rated 12V AC transformer and Illuminex lighting controller are required and sold separately. Pump, valves, PVC pipe, junction box, wall construction and waterproofing materials are not included.

Follow the current approved AquaFall manual for seasonal shutdown. In general: shut down the water-feature circuit, drain the AquaFall plumbing, remove trapped water, protect exposed plumbing from freeze damage, perform an electrical shutdown, and complete a seasonal inspection. Do not rely on turning off the pump alone to prevent freeze damage.